Knot Salted
Senior Member
- Joined
- Mar 16, 2015
- Messages
- 322
- Location
- USA
- Vessel Name
- Knot Salted
- Vessel Make
- 1981 Californian 34 LRC
Hello All,
----QUESTION ANSWERED----
I am editing, as TAD got back with me and is sending 12 compression washers that are .0030 thickness. Close enough for me!
Leaving original post here below....
For the injector compression washer (at base) the Perkins manuals give .0028 up to .008 thickness depending on engine model. My existing washers are very thin. (.0028) The injector rebuilder supplied .008 so I have reused the old washers as a temporary measure.
TAD does not show specs on their kits, so I have emailed them to check.
I do not need the full fuel washer kit. Does anyone have a source for these .0028 compression washers?
-----Again, TAD got them for me!----
Thanks.
----QUESTION ANSWERED----
I am editing, as TAD got back with me and is sending 12 compression washers that are .0030 thickness. Close enough for me!
Leaving original post here below....
For the injector compression washer (at base) the Perkins manuals give .0028 up to .008 thickness depending on engine model. My existing washers are very thin. (.0028) The injector rebuilder supplied .008 so I have reused the old washers as a temporary measure.
TAD does not show specs on their kits, so I have emailed them to check.
I do not need the full fuel washer kit. Does anyone have a source for these .0028 compression washers?
-----Again, TAD got them for me!----
Thanks.
Last edited: