On my boat, I have two Fortress FX-85's. It is 65' and classified as 100tons, but I believe it is close to 50 to 60 tons according to a travel lift.
Currently, it has two anchor rodes of about 5' each. yes 5', no 0's missed.
The anchor rode is 3/8. I am looking to see if that is sufficient still for this boat, or is it better to upgrade to 1/2". The previous owner had plans to use 1.25" nylon rope. He wanted to put 1000ft so he can go out to the gulf and anchor.
Looking at going all chain. 300~400 ft per anchor. The boat was originally equipped with anchors that came out of the side of the bow and the anchor locker was converted into a bunk room. So the weight of the chain is of minimal concern.
I am figuring chain overall is a much better use for this size vessel.
Wondering the experts in this forums input about going to all chain, should I stick with 3/8" or go to 1/2"
Also, I have inlcuded some photos of the windlass in hopes of identifying make and model so I can buy new gypsys for it, if necessary. It is currently equipped with a 3/8" gypsy on each side. My foot is on the motor section in one photo for scale, it is a size 11.
Also, if you know the model, would love the exploded parts diagram as I would love to disassemble, clean, prep, lube, and paint it, so it is like new.
Thank you in advance.
Currently, it has two anchor rodes of about 5' each. yes 5', no 0's missed.
The anchor rode is 3/8. I am looking to see if that is sufficient still for this boat, or is it better to upgrade to 1/2". The previous owner had plans to use 1.25" nylon rope. He wanted to put 1000ft so he can go out to the gulf and anchor.
Looking at going all chain. 300~400 ft per anchor. The boat was originally equipped with anchors that came out of the side of the bow and the anchor locker was converted into a bunk room. So the weight of the chain is of minimal concern.
I am figuring chain overall is a much better use for this size vessel.
Wondering the experts in this forums input about going to all chain, should I stick with 3/8" or go to 1/2"
Also, I have inlcuded some photos of the windlass in hopes of identifying make and model so I can buy new gypsys for it, if necessary. It is currently equipped with a 3/8" gypsy on each side. My foot is on the motor section in one photo for scale, it is a size 11.
Also, if you know the model, would love the exploded parts diagram as I would love to disassemble, clean, prep, lube, and paint it, so it is like new.
Thank you in advance.