Capt.Bill11
Guru
If the varnished surface is nice and smooth all you should have to do is scuff the surface up with say a green scuffy pad to prep it for a coat of varnish.
I'm interested in the views of this group with regards to a "maintenance" coat of varnish on rails. Already have 8-12 (lost count) of varnish, the surface is very glossy, so Cetol not an option. Currently in a boatyard for some mechanical work and asked them to quote the above. The reply came back for 2 coats, stating that their sanding would remove one coat so would need 2 for added build-up. When I have done this my sanding has been much less aggressive, unless I waited too long and the gloss was gone. I would lightly sand the surface to rough it up so the new coat would adhere.
What says the group? (except Mark, he manages to get a good shine on his rails without lifting a brush!)
The most important part of any painting / varnishing is a clean surface. A light scrub with a green Scotch Bright pad (as Capt. Bill stated) with warm water a little dawn and some TSP will give you a surface ready to refinish. (Providing the surface is in half decent condition to start with) Just lightly scrub rinse well and let dry o-night.
Ex Sailor,
I've mixed a lot of my own linseed oil for our teak on the Willard and had mixed results. Works fairly well but a bit sticky for a few weeks and that is about half of it's time between coats. I used raw linseed oil, not purified and on the first few coats thinned w turpentine. Perhaps it wouldn't have been sticky if I had used boiled linseed oil on later coats. Easy to use if you don't mask. When it gets on hard surfaces like paint or gel-coat it attracts a lot of dirt and looks terrible. But if one recoats often enough it protects the wood and gives it the warm wood look most like. I also added about 10 % oil varnish after the soak-in coats.
This Tonkinios site reads a little like a snake oil presentation but I've seen it before .. enen on TF. Most here think oil based stuff is just too old school to be any good .. out w the old in w the new. But we prefer it.
Sure wish you could buy a can of paint w the ingredients listed on the can. It was required by law in the past. Phenolic resin and tung oil or what. Tonkinios dosn't say specifically what's in their product either. I learned years ago phenolic resin and tung oil was the best resin and oil. The vehicle was listed and the percentages of all were there for all to see. Make a cheap varnish? Sure. Just put in more vehicle (solvent) and less resin and oil. No way to tell now.
But I'd like to use some Tonkinios oil and see how it goes.