toocoys
Scraping Paint
Head is a vacuflush. It would fill up with water but wouldn’t go down.
Took it apart this morning and found the duck bill to be disentegrated and there was a pony tail holder wrapped around the blades of the pump.
Installed new duck bill, cleaned pump blades off, reinstalled and.... nothing.
Bowl fills, pump runs, I get swirling action in the bowl, but nothing goes down.
Is my next move to replace the entire line from toilet to tank? How can I verify there is a vacuum to push stuff down?
There is a section of line between the tank and the toilet that has been clamped in place. I suppose I could remove it and blow the lines either way.
I had to stop for today because I’m too irritated to continue.
Took it apart this morning and found the duck bill to be disentegrated and there was a pony tail holder wrapped around the blades of the pump.
Installed new duck bill, cleaned pump blades off, reinstalled and.... nothing.
Bowl fills, pump runs, I get swirling action in the bowl, but nothing goes down.
Is my next move to replace the entire line from toilet to tank? How can I verify there is a vacuum to push stuff down?
There is a section of line between the tank and the toilet that has been clamped in place. I suppose I could remove it and blow the lines either way.
I had to stop for today because I’m too irritated to continue.