Pack Mule
TF Site Team
- Joined
- Jan 24, 2013
- Messages
- 3,749
- Location
- USA
- Vessel Name
- Slo-Poke
- Vessel Make
- Jorgensen custom 44
That might get to complicated for me to plumb . I may try to fill from one fill with a y-valve and draw from separate lines with a valve for each . I’m not sure yet and also not sure if I want to drain from bottom or pull from top. Just getting the right tank or tanks is about to whoop me.Marty will you join the two tanks so you can fill and draw from them at the same time?
Possum had two 25 gallon water tanks, one port and one Starboard. I ran a hose under the engine connecting them. The fill and draw fittings were both in the port tank but I had no trouble filling and emptying both.
I’m overthinking it as always.If this works out I will install two next year on my starboard side. I sure hope Ronco will sell me direct .
Last edited: