k9medic
Senior Member
Good day all,
I am getting ready to do a trial run of my tender towing setup and wanted to get some feedback of my setup.
The tender in question is a 16' Wahoo (whaler clone) that weighs about 1100lbs. I will be pulling it at approximately 7-8kts. behind a Sea Ray 420AC.
I plan on using two 25ft. 5/8" double braided nylon ropes attached to the rear cleats of the Sea Ray. These ropes will then be attached to a stainless shackle to form a bridle that is attached to a 100' section of 3/8" dyneema rope that will attach to the Wahoo tender.
I am getting ready to do a trial run of my tender towing setup and wanted to get some feedback of my setup.
The tender in question is a 16' Wahoo (whaler clone) that weighs about 1100lbs. I will be pulling it at approximately 7-8kts. behind a Sea Ray 420AC.
I plan on using two 25ft. 5/8" double braided nylon ropes attached to the rear cleats of the Sea Ray. These ropes will then be attached to a stainless shackle to form a bridle that is attached to a 100' section of 3/8" dyneema rope that will attach to the Wahoo tender.
Last edited by a moderator: