Talonewo
Senior Member
I need to replace my low oil pressure sender and I can´t find the part number. I contacted our local marine cat dealer and they couldn´t find it either. I have a cat D343TA with an Electronic Protection system, energize to shutoff or ETS. The system will shut the engine off if any of the three conditions are meet, overspeed, coolant over 209 deg or if the oil pressure is too low.
I definitely broke the low oil pressure switch(see attached photo) and I have doubts about the coolant temp switch so I would like that part number too.
The attached pdf file is not my exact ETS system but it is very close, I have the same electronic speed switch and time delay relay.
I have attached the actual wiring diagram of my boat, it may help to decipher what the three prongs do.
The only markings on the switch are the manufacture Kluxon, I called their tech support, they asked for a picture and they see what they and do... confidence is low anything with come of that, my assumption is it is a 40 year old switch.
I attached a pic of the ESS and time delay relay, Anyone out there with one of these old electronic protect systems?
Any ideas where I can start?
I definitely broke the low oil pressure switch(see attached photo) and I have doubts about the coolant temp switch so I would like that part number too.
The attached pdf file is not my exact ETS system but it is very close, I have the same electronic speed switch and time delay relay.
I have attached the actual wiring diagram of my boat, it may help to decipher what the three prongs do.
The only markings on the switch are the manufacture Kluxon, I called their tech support, they asked for a picture and they see what they and do... confidence is low anything with come of that, my assumption is it is a 40 year old switch.
I attached a pic of the ESS and time delay relay, Anyone out there with one of these old electronic protect systems?
Any ideas where I can start?