menzies
Guru
I installed two cameras today - one in the ER and over the stern. I have successfully fed them to the Green Marine 17" Monitor in the PH and they show fine - great in fact.
This monitor is replicated on the FB with the 15" "dumb" monitor - i.e. with no controls. This monitor has been working fine. However when I finished the install and went up there to see the video replicated there was a fixed message on the screen saying "Out Of Timing."
I am stumped on this.
One thing I am going to look at tomorrow is that I set the resolution on the PH monitor to match the resolution I had on the cameras (1280X1024) which that monitor can handle, but the max resolution on the FB monitor is 1024x768.
So I will lower both the camera and the PH monitor to 1024X768 and see if that resolves it.
I am not hopeful though as I wouldn't think a bad resolution would give an "out of timing" message would it?
This monitor is replicated on the FB with the 15" "dumb" monitor - i.e. with no controls. This monitor has been working fine. However when I finished the install and went up there to see the video replicated there was a fixed message on the screen saying "Out Of Timing."
I am stumped on this.
One thing I am going to look at tomorrow is that I set the resolution on the PH monitor to match the resolution I had on the cameras (1280X1024) which that monitor can handle, but the max resolution on the FB monitor is 1024x768.
So I will lower both the camera and the PH monitor to 1024X768 and see if that resolves it.
I am not hopeful though as I wouldn't think a bad resolution would give an "out of timing" message would it?