Nomad Willy
Guru
I'm sealing 20 to 30 holes about 1/4" Dia on the inside deck of my 19' OB boat.
I'm going to use 5200 and hardware cloth (screen) for reinforcement. At first I was set on SS but don't know if I can get the edges to lay flat. I want them to be as flush as possible.
For similar events I've used thin aluminum plate and perhaps I shouldn't stray from past success. But again how could I cut the 3/4" (approx) cutouts w/o curving or warping the flat cutouts. Perhaps there's cutouts for some other purpose that I could buy ready to use. Any ideas?
I'm going to use 5200 and hardware cloth (screen) for reinforcement. At first I was set on SS but don't know if I can get the edges to lay flat. I want them to be as flush as possible.
For similar events I've used thin aluminum plate and perhaps I shouldn't stray from past success. But again how could I cut the 3/4" (approx) cutouts w/o curving or warping the flat cutouts. Perhaps there's cutouts for some other purpose that I could buy ready to use. Any ideas?