ak-guy
Senior Member
I bought one of these:
Does this completely replace both prop nuts? Do you still use a cotter pin? I had put on a shaft zinc between the prop and the cutlass bearing but there is very little space there. I want to be able to remove my flexible coupling, move the shaft forward and mate the flanges together to check alignment in the water. I can't do that with the shaft zinc in place.
Does this completely replace both prop nuts? Do you still use a cotter pin? I had put on a shaft zinc between the prop and the cutlass bearing but there is very little space there. I want to be able to remove my flexible coupling, move the shaft forward and mate the flanges together to check alignment in the water. I can't do that with the shaft zinc in place.