rgano

I have a different hull design, but my side exhaust is a bit in the water. Other than getting rid of the Brait part of my combination...

Slap it with a hammer and hope it does not go thunk.

I had it made by a local upholsterer whose shop was near the house. He was willing to do the odd canvas job over the years on both my...

Here are some more photos of the job. You can see where I gained a lot of visibilty as I hold up the old closure over the new window in...

I have been off the air on this topic for a while as I conducted my research for this project. I finally settled on Wynne Marine in...

Most boats I see with a flat exit out of the skeg like you have are equipped with a cutless bearing housing there.

I cut a four-inch diameter hole in my MS 30 P II's cabin sole to allow me to replace the tripping hazard the table mounting became with...

In addition to the source Bacchus mentioned, look closely at the windshield-to-cabin seam. Also look at the portlight rubber seals. I...

What's next on your list?

Just think how much you learned that day. :)

They shut bridges down here in NWFL at 40 MPH sustained.

Phelps and me?? In regard to the overhang, I'd look at it as something akin to soffit repair of a house. Cut that mess out of there...

I bought my new AP through a local marine electronics dealer who agreed to come to my boat to survey the mounting locations for the...

That's what mine was, Benmar Cetek. The drive motor was indestructible, and if yours is working, not a problem to connect to the output...

My brother (also a TFer) and I had chain and cable drive steering systems on our two Grand Banks 42-footer (you likely have hydraulic)...