Doc
Guru
- Joined
- Oct 5, 2007
- Messages
- 508
I noticed a drip of rust in the bilge and followed up to the exhaust riser. I applied JB Weld to the well scuffed up area around the hole and took the boat out for a ride. The leak came back.*
I have found a new one in Seattle for $885.00 plus freight, a repair place in Alabama the will re weld the seam for $300.00 and a rebuilder in Washington that says that it is probably pitted on the inside and will totally rebuild it for about $600.00.
The reason why I love boats is because I just spent close to $800 on a new bow thruster joy stick and an 8D AGM to operate it. I wish that I had been better at golf back when I was chosing a life time hobby.
I have found a new one in Seattle for $885.00 plus freight, a repair place in Alabama the will re weld the seam for $300.00 and a rebuilder in Washington that says that it is probably pitted on the inside and will totally rebuild it for about $600.00.
The reason why I love boats is because I just spent close to $800 on a new bow thruster joy stick and an 8D AGM to operate it. I wish that I had been better at golf back when I was chosing a life time hobby.