Hello All,
I know some of you have undertaken this project in the past. Need to remove my Simpson Lawrence 700 windlass and the bow pulpit so the later can have some FRP repairs over the winter.
I've loosened the 4 nuts from the studs holding the gearbox/motor, but the unit is not budging. I whacked it a few times with a rubber mallet and it now moves a bit, but not dropping down at all. Any tips??
Any advice on removing the pulpit?
Thanks as always!
Rick
I know some of you have undertaken this project in the past. Need to remove my Simpson Lawrence 700 windlass and the bow pulpit so the later can have some FRP repairs over the winter.
I've loosened the 4 nuts from the studs holding the gearbox/motor, but the unit is not budging. I whacked it a few times with a rubber mallet and it now moves a bit, but not dropping down at all. Any tips??
Any advice on removing the pulpit?
Thanks as always!
Rick