Water in raydome

The friendliest place on the web for anyone who enjoys boating.
If you have answers, please help by responding to the unanswered posts.

Bob Nala

Veteran Member
Joined
Feb 21, 2021
Messages
37
Vessel Name
Alegria
Vessel Make
1981 36' Grand Mainer
Has anyone had this problem? Mine is a Raymarine 3G maybe 10 years old. I opened it up and there was 1/2" of water. No signs of water intrusion, sealed tight as a drum. Quick search suggests condensation from greenhousing effect.
This from Tech support:

Response By Email (Raymarine Tech.) (10/12/2022 03:22 PM)
Water penetration is not a common problem on radars, I recommend you take down the unit and make sure that the parts are properly matching so there is no filtering in the connections.


Technical Support Specialist
Raymarine / Teledyne FLIR
 
Last edited by a moderator:
I have never seen it. It can’t be a good thing. Not sure how I would go about isolating the source thought. Good luck.
 
Had a similar problem with a Simrad dome about five years ago. The unit was only a year old. Brought it back to Navico in Nashua, NH. They replaced it for free. I never could understand how water got in it. It was always vertical up on a pedestal.
 
Have you checked the dome for minute cracks? Maybe use a light to help see if there are any.
 
condensation could form. all my Furuno's have a breather valve. if yours have one make sure its not plugged
 
This issue happened to a friend of mine. If I recall he simply drilled some holes in the bottom of the dome to allow it to drain out.
 
At least the later Raymarine radomes have a breather hole in the bottom, the installation instructions admonish to make sure this isn't blocked. What can happen is this: thermal cycles alternately pressurize and then vacuum the interior. The seals aren't perfect, moist air intrudes on each cycle, then condenses out at night forming a puddle. The puddle does not evaporate and leave, it just grows.
 
You might go to the lowest point in the bottom of the lower housing and drill an 1/8" weep hole. Thermal changes will create condensation.
 
Your installation guide should show the drain hole in the unit. make sure it is clear.
 
Thanks for the replies and suggestions. I believe DDW is the winner. The unit does have a breather port, but nothing in the install manual to suggest a drain hole. If it does decide to reboot, I will drill a drain hole in it and cover it with some mesh to keep critters out.
 
Was the breather hole blocked or restricted?

Nope. But after I looked at how small and tight it was I couldn't imagine it releasing much vapour. It is probably where the air got in after it depressurized at night or after powering down.
 
Back
Top Bottom