JGORT

I was unable to find the square top plug but got an octagonal one for the moment I drilled a 1/8” hole on the top but I will look for...

We were a bit nervous about what would be the outcome. Since we found water in the system bad lines in the bilge oil that had been...

I WOULD LIKE TO TAKE A MOMENT TO THANK ALL THAT RESPONDED AND GAVE ME ADVICE ON THE STEERING LINE ISSUE. THE NEW LINES ARE IN AND PURGED...

We have a 41 President Sundeck. The Stove I purchased secondhand from someone in Port Charlotte Fl. But the switch we purchased on eBay...

Definitely now that the floor is up and I have access I will be replacing all bonding wires and terminals.

I would absolutely make the center section of flooring have pull out hatches with flush pull rings. Having access to the bilge is very...

I was thinking about your advice and my thoughts are possibly making at least one half of the floor removable holding it down with...

Exactly the system was leaking and it should have been fixed. The bilge under the floor was nasty it was traveling forward through the...

You shouldn’t need an open port to add fluid once the system is complete and bled. Close it up or you’ll have water in it again. I can’t...

I would love to run them through another location but I’m stuck like chuck on this one not much room.

Greetings, Mr. J. As noted, water in your hydraulic system is NOT good. Mr. b's advice is sound. Clean, clean, clean. Since you are...

And thank you for the quick response.

Will do I have a pancake compressor and will push air in from the top helm. The previous owner had a hose hooked to a funnel so he could...

If uniflow valve you refer to is the bleed valve hynautic used on their pressurized systems, it's to get air out. If you have water in...

Good afternoon I am replacing the floor in the aft cabin of our trawler. Under the floor I found the old steering lines that had been...