Alaskan Sea-Duction
Guru
- Joined
- Jul 6, 2012
- Messages
- 8,062
- Location
- USA
- Vessel Name
- Alaskan Sea-Duction
- Vessel Make
- 1988 M/Y Camargue YachtFisher
Working on friends 37010. Installed "updated" rebuild kit. Some questions:
1. Flushes fine, plenty of water, but water doesn't swirl all around inside bowl. I cleaned all the holes. Little effect. Lots of water in the back of the bowl, just not up front. Could it be I have the impeller installed backwards?
2. Once flushed the water left in the bowl "bleeds down" to the bottom. The kit came with two rubber gaskets. One black ring and the other a white bigger rubber gasket. The parts blow up/instructions does not show the white gasket. Do I use this gasket? What else could cause the bowl to bleed off?
Thank you
Tom
1. Flushes fine, plenty of water, but water doesn't swirl all around inside bowl. I cleaned all the holes. Little effect. Lots of water in the back of the bowl, just not up front. Could it be I have the impeller installed backwards?
2. Once flushed the water left in the bowl "bleeds down" to the bottom. The kit came with two rubber gaskets. One black ring and the other a white bigger rubber gasket. The parts blow up/instructions does not show the white gasket. Do I use this gasket? What else could cause the bowl to bleed off?
Thank you
Tom