luna

I know nothing about the Victron displays other than what I can see on your screen shots, but I will take a shot at this. The...

Yeah, by way of bluetooth, wifi or hocus pocus you can set the input current to the inverter at a reduced level. By the same method the...

Not to be over critical, but if the inverter/charger is a 3kw model (it's hard to tell) you would need a 350 Amp fuse to allow it to run...

The grounding conductor (normally the insulation is green) could be simply a bare wire without any insulation and likely is so in your...

Provided whatever fitting was threaded onto the exterior end of the tube can still be effectively threaded back onto the tube, this...

'Start Conversation' is the PM.

I've never had any luck having a #10 machine screw drop-in tight into a 3/16" diameter hole as the machine screw is 0.190" and the hole...

9/16" is larger than 1/2", the entire screw including the head would simply fall through the hole. If you are going to use a #8 screw...

The two pins at each end of a straight tube are connected together by the filament, so of course there will be some resistance between...