Egregious
Guru
I don't know why I never noticed this, but frankly the AC voltage gauge isn't that precise. I recently put a multi-tester in an AC outlet with the Genset running at no load. It read 142 volts. Someone at the marina suggested testing the RPM, and that if it was too high that would cause a high voltage reading.
It is a Westerbeke 4.5 WMD, and should run at 1800RPM. I have a manual RPM gauge that I can get a reading directly from the flywheel, so I will check that next time we're on the boat. Anything else I should look at?
The online docs available from Westerbeke don't tell how to adjust anything. I'm going to call them but just thought I'd check here as well.
Thanks in advance.
It is a Westerbeke 4.5 WMD, and should run at 1800RPM. I have a manual RPM gauge that I can get a reading directly from the flywheel, so I will check that next time we're on the boat. Anything else I should look at?
The online docs available from Westerbeke don't tell how to adjust anything. I'm going to call them but just thought I'd check here as well.
Thanks in advance.