Pgitug
Guru
I have a 21000 lb tug with a single bow roller. Looking for a double anchor, one pull from under one pull from over the end, bow pulpit. Anyone have a good source for a beefy new double anchor bow pulpit?
Last edited:
I have a 21000 lb tug with a single bow roller. Looking for a double anchor, one pull from under one pull from over the end, bow pulpit. Anyone have a good source for a beefy new double anchor bow pulpit?
I have a 21000 lb tug with a single bow roller. Looking for a double anchor, one pull from under one pull from over the end, bow pulpit. Anyone have a good source for a beefy new double anchor bow pulpit?
Why go to all that trouble. It's very, very rare that you need to deploy two anchors and with the correct choice of an over sized one that works well in the majority of the types of bottoms you anchor in, you'll almost never need to use two anchors off your bow.
Why go to all that trouble. It's very, very rare that you need to deploy two anchors and with the correct choice of an over sized one that works well in the majority of the types of bottoms you anchor in, you'll almost never need to use two anchors off your bow.
Why go to all that trouble. It's very, very rare that you need to deploy two anchors and with the correct choice of an over sized one that works well in the majority of the types of bottoms you anchor in, you'll almost never need to use two anchors off your bow.
Pgitug,
Just install a second roller. My primary roller was installed at the factory. I installed the Lofrans Tigres windlass, then I installed a second, smaller roller than lines up to the left (port) side windlass rope gypsy. I use the second roller for a lighter lunch or fishing anchor. Pictured is a 29# folding grappling anchor, but I usually carry a 10KG (22#) Bruce in second roller. My primary anchor is a 35# Delta with 200' chain.