Search results

I am in need of a decent Ford Lehman 120 exhaust manifold. Thank you, Jeremy

As promised I am working on the mess of wiring on my boat and am trying to get pictures as I go to document it. I started by climbing into the fly bridge to access the situation up the. Attached are the before, after and pile of wires removed. It is hard to imagine what went through the POwners...

Just wondering what the opinions are on mounting temperature gauge sensors on the end ports of header/expansion tank instead of the cramped space on the cylinder head.

Going through the cooling system on my Ford Lehman 120 and found the 1 3/4” hose nipple almost completely rotted off. Cut the bad part off the tank, faced the tank and bored the hole in the mill, turned a new nipple on the lathe welded it back in place. Almost forgot, I dumped in a bunch of...

Going through the engine, changing fluids, hoses, coolers and heat exchanger. While checking the fluid level in the injection pump before draining, I discovered the oil level screw was stripped….and the injection pump oil was very diluted with diesel. The hole in the boss for this screw seemed...

Any thoughts on using aluminum tubing for the coolant tubes that connect the expansion tank to the heat exchanger at the rear of the engine? Turned these on the lathe out of 1 1/2” sch40 6061 pipe. O/D of tube is 1.750 and the barb at each end is 1.850.

Hello all. I just acquired a 1975 34’ Marine Trader Sedan (traded it for a golf cart to a generous friend). I would have to imagine there are posts on this forum from previous owners. Boat had fuel tanks replaced with poly in 2011. Engine has approx 750 hours on the rebuild. Power is FL 120...