Search results

Check the pressure reg. which is mounted on the side of the Inj. Pump in between the Eng. block, its a bit hard to get at but these can leak or come loose at times, you will need a very thin open ended spanner to get between the Diaphragm body and pump to reach the hex nut, check for tightness...

Hello Kieth, Please see info below for valve adj. on the Volvo TAMD range 61 to 74 FYI. Hope this helps?. John

So true!, I have worked on Diesels - all models for over 50 yrs. you still hear this type of comment all the time, recently worked on customers tender motors - Mercury 4 Stroke Outboards, turns out they are rebadged Tohatsu's!.

Engine Anode Failure? Hello Gulfstar 36, I can see your anode problem, but I think you are missing the condition of your HE tubes!, I would say you are in dire need of a good flush/clean to get the HE Tubes working again to transfer the heat from your fresh water re-circ system to to the raw...

Hello Brisboy, I did not realise there were so many Aussies on this site, thanks for the welcome. After working on so many boats I don't need to own a boat!, I can borrow or test run any of my past customers boats who are very grateful for past work etc. so a very cheap outcome for me and I...

Hello All, I have enjoyed your site for a while as a visitor so I thought I should make it official, hoping I can contribute from my part of the world?. Marine engineer, Diesel specialist and boat builder for 40 yrs.+ up to 100ft. in Aluminium-Steel and Composites over the last 15 yrs. Looking...