Recent content by pacemaker69

I have been doing running gear for 30 years i can tell you this whenever running aground be sure to check all of these items; 1. engine mounts 2. engine alignment. 3. coupling to coupling fit should be pinching all the way around 4. check shaft for straightness. 5. check bearing wear 6. check or...

to release fin inside the bottom of the fin are two holes you have to make a tool to release the bolt inside once done you can then take two wedges at top of fin near shaft one on each side big hammer swing at both steel wedges buy at home depot. crib the fin so fin does not hit the ground...