Recent content by Kmart

Those breakers are on the outside

Thanks , that is a older photo I was using it as reference . The push breakers seem to working fine, but I will check the voltage to be sure.

Yes I have tried swapping the power cord . I even went directly from power pole directly to both inputs individually . Eliminating the “Y” cable The problem appears to stay with input #2 . I will break out the multimeter and see what I come up with thanks

Thanks everyone for your input . I have dual inputs to the boat the are on the same side of the boat which have breakers . I used a single cable 50 amp service connected to a “Y” cable which connects to load 1 and load 2 input receptacle. Which the connects to main Breaker #1 and #2 . I did a...

Thanks Michael. When I position the rotary switch in the 1&2 position the voltmeter on right side shows no voltage does this indicate to you the issue is with the switch or the main breaker#2 ?

Yes this is a new problem . Working for years. I went to boat and both main breakers 1,2 were off. Not sure why but when I proceeded to flip them on only breaker 1 would function . Breaker 2 would go on and (would not trip )just no power to sub breakers on right side of panel. All this occurred...

Thanks I have tried that , no luck . The only way I can get power to all breakers is to put switch in position 1 and and turn on breaker 1 . Is this configuration breaker 2 is not in use .effectively all sub breakers are working off main breaker 1

I have attach a photo to help clarify problem

Hello I have a 1987 mainship Nantucket. I am have a issue with shore power . I have 2 inputs “LOAD I” and “LOAD II” . I also have a switch 1 , 1&2 and Gen above breakers . When in position 1 the all breakers in the panel work. When I switch to postion 1&2 I loose all breakers on right side of...