Recent content by Kelsey

Thanks, The only place I'm allowed to go to is the boat yard to work on my boat. I will check those items out. Incidently, I just replaced my "fire-Safe" module ($350) I hope the display is ok, that is below the rudder indicator on the port side of the wheel.

Hey, Thanks for the fast response. I'm not getting any alarms, my gauges all work though. So I will test around to see if the alarm works and run that back to the gauge and sensors. I know there is at least one sensors transmission temp, with no gauge, so I would expect an alarm or light for...

I have a 2003 with a single Yanmar 6LPA-STP engine and I don't get the alarms when starting the engine. As I understand, Mainship did it's own wiring, so I was hoping someone has the schematic for my configuration. Is it possible that Marlow would have the specs from the older Mainship models...

I'm replacing my Ray SC70 systen with a Simrad 3G and NSO display. The install recommends a RC42 heading sensor, which is available to purchase, but various sites state that is in a discontinued product. Is there a new replacement for this? Or should I just use it? Thanks

Thanks for the tips, big help!

Anyone know an easier way to remove old fuel lines or high pressure lines that are hardened and stuck on fittings?

I was wondering if it is possible to obtain assembly drawings for my Mainship Pilot so I can plan some maintenance. I need to fix leahs coming from the gunnels, rails etc ( not sure) BUT IT WOULD BE GOOD TO SEE HOW THEY ARE CONSTRUCTED BEFORE I START removing anything.