della li

So no water intrusion that I can see. The crack appears to be shallow, and basically just across the top--I was able to sand off one...

RE bonding in the AC ground on the Sundowner--can I run a wire from the main ground connection on the AC side of the panel (I.e. the...

hmm so can it would not be necessary to run a separate bonding wire from the individual 12v components? I can run a wire from the...

Hi All--noticed this crack in a fiberglass "hump" aft of the stuffing box and apparently just forward of where the shaft enters the...

Yes, just exploring an alternate way of bonding to an exterior zinc

Ah ok got it. Thx.

Folks, i notice a crack in the top of this figerglass "hump" where I guess the shaft enters the shaft log--not sure the purpose of the...

Another related Q: can I connect the neutral (DC) and ground (AC) bus bars in my distribution panel to a separate common bus, assuming...

THx! How do I assue the connection will not be over 1 ohm?

Hi Folks-- A rubber line, maybe 1/2"--3/4" running to the exhaust mani,a bout midway, has a slight leak, but not sure what type fluid...

Any tips for accessing impellers on a Yanmar 4 ph-te in a 30' Sundowner? The seawater impeller seems inaccessible without at least...

Can a hanging zinc be used for electircal bonding purposes--i.e., attaching the cable to the bonding bus? Trying to figure a way to bond...

Thx fot the detailed resp. So if after connecting the AC and B- buses, I can ground to the engine and that will carry through to...

Also some folks have suggeted bleach? Any thoughts on the difference (chloring v bleach), and what the ratio might be for the latter?

So one cup of a12% chloring solution? So add that to the fresh tank (less than a cup if a smaller tank), then run the hot water til it...