Phil23
Senior Member
- Joined
- Jul 29, 2013
- Messages
- 207
- Location
- Russell NZ
- Vessel Name
- MV Unique
- Vessel Make
- Salthouse Coastal 35
Hi Guys I may well be on a hiding to nowhere with this one. I have just had to install a new Maxwell Windlass and as my luck has it my Positive Battery Lead (AWG4 I think) is 200mm too short. It is not as simple as pulling the existing cable and replacing with a new as the builders in their wisdom glassed the cable in from just above the waterline through to the engine room. My question(s) are how can I join maybe 180mm of cable to the existing and then to the reversing solenoid without soldering ie a crimp jointing fitting
Give the short run to the reversing solenoid could I use a slightly lesser cable to ease the job.
Look forward to comments
Give the short run to the reversing solenoid could I use a slightly lesser cable to ease the job.
Look forward to comments