View Single Post
Old 01-17-2020, 11:05 AM   #15
pacemaker69
Newbie
 
City: Ft. Lauderdale
Join Date: Jan 2020
Posts: 2
to release fin inside the bottom of the fin are two holes you have to make a tool to release the bolt inside once done you can then take two wedges at top of fin near shaft one on each side big hammer swing at both steel wedges buy at home depot. crib the fin so fin does not hit the ground causing damage at this point you can begin the disassembly process starting from the top of the stabilizer. get a qualified Naiad tech or dont do it.
pacemaker69 is offline   Reply With Quote