Fighterpilot
Senior Member
- Joined
- Apr 17, 2011
- Messages
- 380
Can I feed both my Garmin 2010c and 2006c from one transducer. I have the 20 sonor unit for the 2010 but the boat came with a 2006c, no transducer. Going to use separate antennae for GPS function, but hate to have to put in two transduers.
Up date on Amazing Grace. Took boat out today for a little shake down cruise and some fishing.* Fishing was bad but the shake down was productive. Port engine overheat taken care of after cleaning the heat exchanger and opening up the water holes in the riser. Got to do the same for the starboard engine now. Got to pull the toilet--filled up with water--holding tank empty but may be a back flow valve in it that is malfunctioning. Macerator pump on it runs, water swirls but doesn't empty the bowl. I had problems with the overboard thru hull leaking and when I used stand alone macerator as a pump out thru the waste port pulled sea water into the holding tank. Shut thru hull, replumbed hose so loop above the water level in the event thru hull leaked, and had vent fitting off to replace so know tank started the trip empty. Suspect problem in toilet???
Big problem however, on the way home some "slipage" in port engine drive train when adding power above about 1500RPM. Prop? Tx? Gave the impression the transmission was slipping--engine would rev. than system would "catch". MG 502 on 3208N, 1983 vintage. Checked tx. fluid when I got home==looks overfilled to me. No pressure gage on this set up so can't tell pressures. Not sure what to do next. Have a Great New Year.
Up date on Amazing Grace. Took boat out today for a little shake down cruise and some fishing.* Fishing was bad but the shake down was productive. Port engine overheat taken care of after cleaning the heat exchanger and opening up the water holes in the riser. Got to do the same for the starboard engine now. Got to pull the toilet--filled up with water--holding tank empty but may be a back flow valve in it that is malfunctioning. Macerator pump on it runs, water swirls but doesn't empty the bowl. I had problems with the overboard thru hull leaking and when I used stand alone macerator as a pump out thru the waste port pulled sea water into the holding tank. Shut thru hull, replumbed hose so loop above the water level in the event thru hull leaked, and had vent fitting off to replace so know tank started the trip empty. Suspect problem in toilet???
Big problem however, on the way home some "slipage" in port engine drive train when adding power above about 1500RPM. Prop? Tx? Gave the impression the transmission was slipping--engine would rev. than system would "catch". MG 502 on 3208N, 1983 vintage. Checked tx. fluid when I got home==looks overfilled to me. No pressure gage on this set up so can't tell pressures. Not sure what to do next. Have a Great New Year.