View Single Post
Old 02-05-2018, 11:32 PM   #90
FOG
Guru
 
FOG's Avatar
 
City: Wilmington, NC
Vessel Name: DreamQuest
Vessel Model: Prairie 36
Join Date: Jan 2016
Posts: 550
Holding Tank Progress

I've made a little more progress on installing the holding tank over the past few days. I screwed, glued, and painted the plywood enclosure then dropped the Ronco tank inside.

My plan was to do the plumbing required for the bottom of tank before I install it on the boat since it won't be accessible once installed. So two of the pictures show the bottom side with the PVC plumbing and it's supports.

The other picture shows it in it's final resting place on the boat. I still need to finish up the top, which will become the new floor in the engine room. Then finalize the plumbing to connect the toilets, deck pump out, and vent line.
Attached Thumbnails
IMG_0972.jpg   IMG_0973.jpg   IMG_0977.jpg  
FOG is offline   Reply With Quote