kartracer
Guru
- Joined
- Aug 5, 2014
- Messages
- 529
- Location
- USA
- Vessel Name
- M/V LUNASEA
- Vessel Make
- 45ft Bluewater Coastal
During the parade last night the CO2 alarms went off. Went into engine room and found that port exhaust silencer, muffler, split at the seams, letting water and exhaust into the boat, made of rubber. Took 4 vise grips closed seam and back on the way. My question is " is there a product that I can glue or seal the seam back together with and save the $400. Was thinking of 5200 or is there something else that I can inject into the seam that will hold. I know it is the exhaust and not anything to play around with.