Adjusting Morse dual SR controls

The friendliest place on the web for anyone who enjoys boating.
If you have answers, please help by responding to the unanswered posts.
See posts with no answers
C

cody707

Member
Joined
Jul 18, 2010
Messages
7
I have twin transmission controls, from 2 stations.* Each station works fine no cable binding or resistance when disconnected.* But put upper and lower station together the upper station locks.* The controlls were loose inside and I tightened them up and rebuilt them.* They were thight before the rebuild, now they won't work together.

Any suggestions were to begin?

Thanks,

Carl*
 
Hate to say it but I think the facts point to something you may have done when you "rebuilt" them.

Is it possible a part could have been installed backwords and the controls are somehow working against one another.

Just a thought.* JohnP
 
Thanks,

But when the upper and lower are hooked sepratly to the transmissions they work flawlessly.

When both are connected, ( upper to lower ), they lock and neither will move!

Thanks,
 
If I'm not mistaken, they connect through a "DS" plate (Morse ). If this is the set up you have, I would look at this plate where both stations come in and 1 cable goes to the gear box.
 
You must log in or register to reply here.

Similar threads

P
Morse cables not working
Replies
11
Views
2K
jgwinks
J
wkearney99
Twin Disc control parts?
Replies
2
Views
845
lwarden
lwarden
mvweebles
Dual station Morse controls - how are cables run?
Replies
3
Views
4K
mvweebles
mvweebles
Mambo42
Fire scare
2
Replies
42
Views
3K
Mambo42
Mambo42
Adopo
Stability and righting ability
Replies
19
Views
3K
Hippocampus
H

Latest posts

Back
Top Bottom