78puget-trawler
Guru
OK, so I was doing some ER work today, and of course the floor and table are up. I had the folding table on the settee on top of the narrow floor section while I was working below. I checked to see that all was stable and went to work. Well, later after some back and forth, I was right on top of the engine when I heard something, looked up and wham!!, that table had slid off and came down right on the bridge of my schnause. You know how heavy that table is! So, I was bleeding from the outside cut but not inside so probably isn't broken but is sore and may end up with raccoon eyes, don't know yet. Problem for me is one of the hinges for the table broke, I found the chunks later. This is one of those goofy looking hinges that look to be made of pot metal and consist of several layers of flat pcs. that hinge on a pin or pins I guess. I didn't have my camera along to picture it, but I thought maybe one of you CHB guys might know if its even possible to replace that type of hinge or if something new must be fit. Thanks in advance for any info!! I can post a pic later if it helps.
Scott
Scott