View Single Post
Old 09-17-2013, 03:58 PM   #1
rgrstff
Member
 
City: Cape Coral FL
Join Date: Apr 2013
Posts: 11
New with a 1983 34 mainship III bad pillow block

Hi everyone
This is great I've already received help from (Jleonard), but thought that my questions here might help other people more. So everyone is up to date on my problem, I have a bad pillow block bearing and would like to change it in the water. My questions are, do I have to remove the rudder, and if so How? I can disconnect the top I just don,t know about the bottom. Is there enough room to clear the rudder with the Bronze shaft if I remove just the prop? Can I reinstall the pillow block on the trans side of the bulkhead or does it half to be on the prop side?
thanks for any replies
roger
rgrstff is offline   Reply With Quote