Hey guys- for whatever reason, my 1982 Albin 40 DC did not come with the back cushions for the settee and I want to build them myself. What I need help with is how to bend the 1/2” plywood for the corner piece. I don’t want a hard 90° corner but one with the radii. I had two thoughts:
A.) rip multiple cuts with a table saw through to the last layer of ply, soak wood in water, bend then epoxy in the cuts so it keeps it’s form.
Or
B.) rip strips of the ply on angle to form the bend. Say 6 strips at 15°. Then glue the strips together to and sand the edges for a smooth curve.
Below I have attach a picture of the settee. Any tips or ideas would be appreciated.
A.) rip multiple cuts with a table saw through to the last layer of ply, soak wood in water, bend then epoxy in the cuts so it keeps it’s form.
Or
B.) rip strips of the ply on angle to form the bend. Say 6 strips at 15°. Then glue the strips together to and sand the edges for a smooth curve.
Below I have attach a picture of the settee. Any tips or ideas would be appreciated.