View Single Post
Old 08-21-2021, 04:03 PM   #49
boomerang
Guru
 
boomerang's Avatar
 
City: Kilmarnock VA
Vessel Name: Wandering Star
Vessel Model: PSN40
Join Date: Apr 2016
Posts: 1,395
I went to the boat today but don't feel like I got a lot done. I didn't get to reassemble the bell housing ,starter & cooler because I left the bag with the bell housing mounting bolts at the shop where I had the engine work done. Dumb me. On the engine, I did replace the secondary fuel filter ,install the new clutch damper plate ,paint the engine mounts & oil cooler/filter assembly so it wasn't total loss.
On the boat I re-bundled & re-secured the wires & fuel line that were fastened to the stringers. I also installed a new Rule 33 float switch & Rule 1500 pump since the access will never be easier. The old pump went into the spares box.
I painted the area under the engine down to the keel which the whole area a clean look.
I guess tomorrow I'll start polishing the hull but I'm not looking forward to that task!
Attached Thumbnails
102_0259.jpg   102_0260.jpg   102_0261.jpg  
__________________
-Shawn-
boomerang is offline   Reply With Quote