View Single Post
Old 08-02-2021, 06:06 PM   #5
HiDHo
Guru
 
HiDHo's Avatar
 
City: Beverly Hills
Join Date: Feb 2012
Posts: 1,371
I’m no expert but I would remove the injectors, put some motor oil in each cylinder enough to cover the piston head so the cylinder walls get coated. Then turn the engine flywheel by hand to loosen up the rings. I would change the oil and filters before starting it. Clean fuel, bleed the injectors, cross your fingers and try starting it. Good Luck
HiDHo is offline   Reply With Quote