Do the suggested checks.
I lost reverse while entering my shed years ago. Lucky no speed involved.
I found the clamp on the shifter had loosened so the SHEATH was moving instead of the core. I reset it all and used SMALL SCREW Locktite on the machine screws. At worst if SMALL SCREW not available use the BLUE sparingly..
I later found the sheath clamp AT the gear control was asking for a reason to goof up.
The lock which held the sheath into place was open. It was just dumb luck nothing went wrong. I wired the lock into place.
If the sheath clamps have loosened so the sheath can move shifting will become unreliable or non existent.
Check all for a loose clamp.
|