Showing results 1 to 16 of 16
Search took 0.02 seconds.
Search: Posts Made By: Ksoulant
Forum: General Discussion 01-16-2020, 10:17 AM
Replies: 2
Views: 188
Posted By Ksoulant
D/C Charging System

Good Morning all; I am looking for advice on how to set up my D/C charging system. The batteries are Generator Battery G24, Port and Stb. 8D Batteries and 6-6volt house batteries. When connected to...
Forum: General Discussion 08-09-2019, 09:25 AM
Replies: 33
Views: 1,944
Posted By Ksoulant
Furuno is the best with the best service....

Furuno is the best with the best service. Especially when they have the ability to fix 20-30 year old units thatís why 99% of the commercial fleet uses them. Garmin or Raymarine, if they malfunction...
Forum: General Maintenance 06-24-2019, 09:03 AM
Replies: 5
Views: 289
Posted By Ksoulant
Raritan ice maker not making ice

My Raitan ice maker is running and very cold but not making ice. I checked the water supply and have water to the electronic valve. I thought the valve may be bad so I changed it with a new one, put...
Forum: Anchors and Anchoring 10-23-2018, 02:38 PM
Replies: 6
Views: 1,366
Posted By Ksoulant
Koliver, According to the manuals the old Sampson...

Koliver, According to the manuals the old Sampson Lowrance sprint 1000 only has a 400w motor with a working load of 165lbs. According to the Lewmar HX1 GD 800 manual it has a 800w motor and a working...
Forum: Anchors and Anchoring 10-23-2018, 08:18 AM
Replies: 6
Views: 1,366
Posted By Ksoulant
I pulled the trigger. I just placed my order...

I pulled the trigger. I just placed my order through West Marine for the HX1 GD 800w, model #69140037 it should be available for pick up on Friday. I will have to increase the mounting stud length...
Forum: Anchors and Anchoring 10-22-2018, 02:58 PM
Replies: 6
Views: 1,366
Posted By Ksoulant
Did you Purchase this windlass? I am looking at...

Did you Purchase this windlass? I am looking at this one also. how has it worked out so far?
Forum: Electrical and Electronics & Navigation 08-06-2018, 01:23 PM
Replies: 3
Views: 320
Posted By Ksoulant
Well along the Gulf Coast right now it is in the...

Well along the Gulf Coast right now it is in the low to mid 90's, the water temp. is 84, and with the engine and generator running in the engine room i would say about 110-115. but that is not...
Forum: Electrical and Electronics & Navigation 08-06-2018, 09:10 AM
Replies: 3
Views: 320
Posted By Ksoulant
Raymarine CAM50 Over Heating

The Cam50 camera in the engine room works until the temperature in the engine room starts to heat up. It starts flashing on and off every minute or so and as the engine room heats up it flashes on...
Forum: Power Systems 01-10-2017, 12:55 PM
Replies: 18
Views: 1,689
Posted By Ksoulant
No.

No.
Forum: Power Systems 01-10-2017, 12:49 PM
Replies: 18
Views: 1,689
Posted By Ksoulant
Drive train vibration Cat 3208T with Twin Disc MG 506-1

Thanks! for all the responses!
Follow Up;
Well I met with the yard yesterday to discuss the issues and to check the work they did. We disconnected the couplings and checked what the yard was...
Forum: Power Systems 01-09-2017, 10:45 AM
Replies: 18
Views: 1,689
Posted By Ksoulant
What I see and feel is 90% of the vibration is at...

What I see and feel is 90% of the vibration is at 1500-1800RPM. Do you mean if the engine vibrates in neutral I could have a damper problem? and would the damper make the shaft and coupling out 20...
Forum: Power Systems 01-09-2017, 09:58 AM
Replies: 18
Views: 1,689
Posted By Ksoulant
Drive train vibration Cat 3208T with Twin Disc MG 506-1

I have owned a Jefferson 46 with twin 260hp 3208T for the past few years and have always felt some vibration and of course most of the vibration is at the best cruising RPM (1500-1800). I measured...
Forum: Electrical and Electronics & Navigation 04-10-2013, 10:20 AM
Replies: 162
Views: 11,804
Posted By Ksoulant
To install a Sub panel you would have to rewire....

To install a Sub panel you would have to rewire. That means removing the circuits from the main panel finding a location for the Sub panel etc. etc. etc. what a pain in the a** Why not just replace...
Forum: Electrical and Electronics & Navigation 04-04-2013, 04:32 PM
Replies: 162
Views: 11,804
Posted By Ksoulant
Panel Switch for Shore Power, Gen, Inverter

To easily run items off the inverter. I just replaced my 3 postion selector switch with a 4 postion switch from Newmar. You can select from Shore Power, Gen set, Inverter or Off. Before selecting...
Forum: General Maintenance 12-14-2012, 11:21 AM
Replies: 14
Views: 2,214
Posted By Ksoulant
I'm sorry I may not have been clear on my...

I'm sorry I may not have been clear on my original post.The genset draws from the same fuel manifold that the main engines draw from and the genset fuel return is to the port tank. If I open the port...
Forum: General Maintenance 12-13-2012, 11:38 PM
Replies: 14
Views: 2,214
Posted By Ksoulant
Listing problem

Boat listing problem
I’m trying to figure out how to get rid of an ever changing list to starboard. I will try to explain as best as I can. First here is the model of the boat and on board systems...
Showing results 1 to 16 of 16

 
Forum Jump


All times are GMT -5. The time now is 06:20 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2006 - 2012
×