JMYSS
Senior Member
- Joined
- Aug 8, 2010
- Messages
- 154
Unit was taken out for service during repower. Low hours and oil samples negative for contamination, but it was found that the unit had overheated at some point and not noticed do to installation. Unit was taken out, overhauled, found one of the main bearings scratched. Replace all bearings, had head checked and gone thru by machine shop, new water pump, new hoses, new PCB board, two new drip trays (Kohler was out of stock, had a custom aluminum tray fabricated then one showed up from Kohler) new vibration dampening mounts, filters,thermostats, fresh water pump, sensors belts, seals, gaskets, etc. etc. spent over $2,500 in parts before owner went in a different direction. Unit is still torn down, all new parts still boxed up. Selling as is or may put back together and sell for more. Had 984 hours on it when removed. Will try to put together complete parts list of what was replaced $1,900 9106201844
**UNIT IS NOT PUT BACK TOGETHER, MANY EXTRA PARTS....
**UNIT IS NOT PUT BACK TOGETHER, MANY EXTRA PARTS....