GoldenDawn
Senior Member
At my next haul out (within a month), I will be installing a new Interphase Probe transducer. The transducer diameter is 1". I am going to remove an existing paddle wheel speed sensor (very old) which has a diameter of ~1 3/4". I have a new fairing block or may be able to use the existing fairing block. I am expecting to refill the hole with epoxy and re-drill the plug with a 1" hole. Here's my question - should I also put a glass mat layer inside or should the epoxy plug be sufficient (fairing block should provide good overlap over both the inside and outside of the hole)?
Any other suggestions appreciated.
Any other suggestions appreciated.