Best anchor paint

[Simi 60]

I don't think I could fit my anchor into the oven that comes with the Force 10 propane stove??? The anchor is too big!

Ours wouldn't fit in the sizeable boot of a 6 cylinder car.
Had to take a 6x4 trailer out to the warehouse to collect it.

 

[Shrew]

Steel is either painted or galvanized to prevent rust. I've only ever seen cheap, dinghy mushroom anchors have painted steel and it never lasts that long.

I would either re-galvanize or replace. If the PO painted their anchor to buy time, then it's time.

 

[Mako]

To give some feedback, I just painted my CQR. Used etching primer followed by flat Rustoleum black (‘cause that’s what I had laying around).

Then I baked it in the BBQ for 2 hours at 200 degrees F. It has a relatively hard finish but it does abrade. Not as tough as when I used two part epoxy.

 

[AquaDestiny]

Greeaat, thanks a lot Mako, now I have another project to put off...