magna 6882

Good job. I am glad it came out for you.

try to get the threads cleaned up with a all thread up the center then rent a hollow core hydraulic cylinder to pull it out. It will...

The reamers i use are only tapered art way so you start the hole with the tip of the reamer and the flutts on the reamer go straight a...

Another idea that just came to me that we use is to drill the desired hole size in a piece of 1 inch stock and place the jig over the...

The reamers are usually fairly long. Sometimes we will drill a small hole then we can use the reamer to get any angle we want. Straight...

I use a tapered reamer if i need a larger hole in something.trying to enlarge a hole cleanly is a challenge once drilled. The reamer...

we use it almost every trip.

I think there are sometime some confusion regarding bonding and grounding.Grounding is the third wire in you ac and the signal is taken...

What i did was took a piece of rectangular tubing 3/4x2 inch and cut it around 12 inches long. It slides over the existing handle so now...

when i started playing with boats in the 70s things didnt seem that expensive and perhaps i was just to young but fast forward to today...

I had to open the charge air inlet end to remove a zinc that came loose. The design puzzles me. There seems to be divider between the...

Mt transmission cooler has some growth on it and i was going to make a flush kit and run barnical buster through it. I got to looking at...