O C Diver

If you need to rapidly turn the rudder, either a jog lever or the port and starboard push buttons on the display are faster than...

Yes, you want aluminum anodes for the Great Lakes. I tend to buy the longest ones and cut them down to fit. Ted

The above are probably correct, or maybe it toggles between two tanks. Ted

I'm a fan of rodding out heat exchangers. My tool of choice is solid copper wire sold at Home Depot or Lowes. You can buy it by the foot...

I'm a fan of Kiwigrip. One of the nice features is that you can make it as aggressive or minimal as you want. For my swim platform it's...

If you can reach the vent easily, it's a good practice to push a little water from a hose to make sure the line is clean after pumping...

Not only would I have the separate control for the autopilot, but it wouldn't share an electrical circuit with anything else. I can live...

Ok, my next guess is maybe a drain from the refrigerator. Some frost free refrigerators drain the water from the defrost cycle to a pan...

The galvanize wears and chips going through the cats paw and dragging across debris on the bottom. Use it enough and you'll have rust...

While I'm not sure, one place I would look would be the condensate drain for the air conditioners. Not uncommon for "wet" bilge boats to...

If you can't get accommodations there, give Gulf Harbour Yacht and Country Club a call. They're fully rebuilt (other than the pumpout)...

Sold. Ted

There was an article in Passage Maker maybe 15 years ago on converting twins to a single generator with twin electric motors to drive...

Wondering if you could make a dowel that would easily fit inside the pipe, and use it as a pilot for a hole saw to cut away some of the...

I would encourage you to try a listing on TF and see what response you get. I listed mine on TF and was under contract 5 days later...