The friendliest place on the web for anyone who enjoys boating.
If you have answers, please help by responding to the unanswered posts.

See posts with no answers

The repaired panel installed in the forepeak. That's Makore veneer and is not readily available; I had to scrounge a bit from concealed areas for fac

The repaired panel installed in the forepeak. That's Makore veneer and is not readily available; I had to scrounge a bit from concealed areas for fac

Ready for sanding, staining, and finish. These panels were coated out on back and edges with epoxy so that they will not again be affected by water.

Clamping and gluing.

The panel from the head was in terrible condition. (The head port opens and apparently had been left open occasionally.) That's the inner face venee

The panels and other trim components from the forepeak being stained to regain color and urethaned.

Clamping and gluing. The port cutout was very handy. Otherwise, I'd have had to ballast the stack of glued veneers.

Work in progress.

The repaired panel installed in the forepeak. That's Makore veneer and is not readily available; I had to scrounge a bit from concealed areas for fac

DHeckrotte
May 16, 2016

There are no comments to display.