IntoTheBlue
Senior Member
- Joined
- Jan 10, 2016
- Messages
- 151
- Location
- USA
- Vessel Name
- Into The Blue
- Vessel Make
- Mainship Pilot 43
I had dual Raymarine E80 MFD's, which I had replaced with dual Axiom 9's when upgrading my electronics. I had installed years ago 3 CAM100 video camera's that where connected to the E80. Each camera has a 4 pin wire that connects to a BNC/power splitter. Two wires go to power/ground, the BNC connected to an adapter to the E80, which hosted 4 cameras.
Reading one of the Raymarine Forums, Chuck had mentioned that it is possible to use the CAM100 by using an Axis M7011 video encoder. I have put the M7011 inline between the Network on the Axiom and the BNC to the CAM100 camera. I supplied power to the CAM100 (already connected) wires that are part of the BNC/power splitter. The result was nothing happened and the power LED on the M7011 was not lite. So I am assuming that the BNC is not supplying power.
Is PoE needed to power the M7011? Anyone have some experience with converting analog to IP cameras?
Thanks!
Reading one of the Raymarine Forums, Chuck had mentioned that it is possible to use the CAM100 by using an Axis M7011 video encoder. I have put the M7011 inline between the Network on the Axiom and the BNC to the CAM100 camera. I supplied power to the CAM100 (already connected) wires that are part of the BNC/power splitter. The result was nothing happened and the power LED on the M7011 was not lite. So I am assuming that the BNC is not supplying power.
Is PoE needed to power the M7011? Anyone have some experience with converting analog to IP cameras?
Thanks!
