Tidahapah
Guru
- Joined
- Oct 7, 2007
- Messages
- 1,859
- Location
- Australia
- Vessel Name
- Flora
- Vessel Make
- Timber southern cray boat
Have just bought and fitted a Gobius tank level monitoring system for my polyethelene holding tank.
So far very impressed.
No cutting or drilling, just stick 3 sensors on the outside of the tank, install the indicating panel up in the main toilet near the pump out switch, connect the system to* 12 V system and then calibrate the unit and Bob's your Uncle.
So far it is doing the job nicely and dead simple to fit.
I got mine from Defender, and must admit I knew nothing about them just bought it because it looked like what I wanted and with no cutting or drilling seemed simple.
will let you all know if I have any trouble with it in the future.
So far very impressed.
No cutting or drilling, just stick 3 sensors on the outside of the tank, install the indicating panel up in the main toilet near the pump out switch, connect the system to* 12 V system and then calibrate the unit and Bob's your Uncle.
So far it is doing the job nicely and dead simple to fit.
I got mine from Defender, and must admit I knew nothing about them just bought it because it looked like what I wanted and with no cutting or drilling seemed simple.
will let you all know if I have any trouble with it in the future.