Madhatter53
Veteran Member
My heads are seawater flush and I'm done with the stink. Can I just plumb my freshwater to the pumps and be done with it?
My heads are seawater flush and I'm done with the stink. Can I just plumb my freshwater to the pumps and be done with it?
My heads are seawater flush and I'm done with the stink. Can I just plumb my freshwater to the pumps and be done with it?
My heads are seawater flush and I'm done with the stink. Can I just plumb my freshwater to the pumps and be done with it?
I have the orig install manuals somewhere. I'm concerned with the city water pressure causing an issue, I do have a regulator on the city water side but I'm sure it's set at 60-80psi which is much more than what coming from my thru hull.
I would, and did, replace with new Raritan Marine Elegance heads. They can be had for about $600 each. Retrofitting will be somewhat less expensive but, then, you end up with a cobbled together system rather than a near bullet-proof set-up, flysh and forget for five or ten years.
You make a good point. Going to re-think my Crown coversion.
Other than the pressure from dockside water hookup what's the dif.
The GM doesn't know the dif between fresh and saltwater.