Lou_tribal
Guru
Hello fellows!
I know I already post questions on the subject but redoing my 12v install aboard here is another one.
Thinking about what I plan I came up with the following schema:
On the drawing only positive cables are shown and all cables are of the same size 2/0.
I think I covered everything regarding fuse and/breaker. I intentionally left the starter non protected as well as alternator.
To distribute alternator power I am not sure yet if I will reuse the isolator/splitter I already have (that was used in the original setup) or if I will add another ACR (better option).
Any comment about that schema? Anybody see anything wrong?
As usually any input will be very welcomed.
L
I know I already post questions on the subject but redoing my 12v install aboard here is another one.
Thinking about what I plan I came up with the following schema:
On the drawing only positive cables are shown and all cables are of the same size 2/0.
I think I covered everything regarding fuse and/breaker. I intentionally left the starter non protected as well as alternator.
To distribute alternator power I am not sure yet if I will reuse the isolator/splitter I already have (that was used in the original setup) or if I will add another ACR (better option).
Any comment about that schema? Anybody see anything wrong?
As usually any input will be very welcomed.
L