View Single Post
Old 04-28-2019, 08:58 PM   #5
AKDoug
Guru
 
AKDoug's Avatar
 
City: Kenai, Alaska
Vessel Name: Melanie Rose
Vessel Model: 1999 Willard PH
Join Date: Feb 2013
Posts: 1,236
The shaft was pre machined for the prop taper and nut, it was to be cut to length and machined for the coupler with a new key. Since the shaft was already a length, I am sure I would have been paying for the unused portion of the shaft also. They would have had no use for the excess length they trimmed off. I don't recall how much excess length there was in the shaft.
AKDoug is offline   Reply With Quote