Phil23
Senior Member
- Joined
- Jul 29, 2013
- Messages
- 207
- Location
- Russell NZ
- Vessel Name
- MV Unique
- Vessel Make
- Salthouse Coastal 35
Further to an earlier post
seeking help on installation I have now fitted my zinc anode block to the transom underwater area and wired shaft shaft tube and stuffing box plus rudder stock tube and gland to to the anode via a bus bar. I also fitted an anode to the end of my shaft. Initially my motor was also bonded to anode via bus bar.
The problem I am experiencing is the blowing of of antifoul in the anode vicinity and am at a loss as to the cause.Cheers Phil
seeking help on installation I have now fitted my zinc anode block to the transom underwater area and wired shaft shaft tube and stuffing box plus rudder stock tube and gland to to the anode via a bus bar. I also fitted an anode to the end of my shaft. Initially my motor was also bonded to anode via bus bar.
The problem I am experiencing is the blowing of of antifoul in the anode vicinity and am at a loss as to the cause.Cheers Phil
